LG T2735NTWV Owner's Manual page 17

Connecting one touch type hose to tap without
thread
1
Unscrew the adapter ring plate and loose the four
fixing screws.
Ring plate
2
Remove the guide plate if the tap is too large to fit
the adapter.
Guide plate
3
Push the adapter onto the end of the tap so that
the rubber seal forms a watertight connection.
Tighten the adapter ring plate and the four fixing
screws.
4
Pull the connector latch plate down, push the inlet
hose onto the adapter, and release the connector
latch plate. Make sure the adapter locks into place.
Latch plate
16
NOTE
• After connecting the inlet hose to the water
tap, turn on the water tap to flush out foreign
substances (dirt, sand, sawdust, etc.) in the water
lines. Let the water drain into a drum, and check
the water temperature.