Package Contents; Markings On Tool - DeWalt XR DCD716 Manual

Table of Contents

Advertisement

In most instances, shipping a D
excepted from being classified as a fully regulated Class
9 Hazardous Material. In general, only shipments containing a
lithium-ion battery with an energy rating greater than 100 Watt
Hours (Wh) will require being shipped as fully regulated Class 9.
All lithium-ion batteries have the Watt Hour rating marked on
the pack. Furthermore, due to regulation complexities, D
does not recommend air shipping lithium-ion battery packs
alone regardless of Watt Hour rating. Shipments of tools with
batteries (combo kits) can be air shipped as excepted if the Watt
Hour rating of the battery pack is no greater than 100 Wh.
Regardless of whether a shipment is considered excepted
or fully regulated, it is the shipper's responsibility to consult
the latest regulations for packaging, labeling/marking and
documentation requirements.
The information provided in this section of the manual is
provided in good faith and believed to be accurate at the time
the document was created. However, no warranty, expressed or
implied, is given. It is the buyer's responsibility to ensure that its
activities comply with the applicable regulations.
Storage Recommendations
1. The best storage place is one that is cool and dry away
from direct sunlight and excess heat or cold. For optimum
battery performance and life, store battery packs at room
temperature when not in use.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool, dry place out of the charger for
optimal results.
nOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be recharged
before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the
labels on the charger and the battery pack may show the
L
following pictographs:
Read instruction manual before use.
p
See Technical Data for charging time.
q
Do not probe with conductive objects.
r
Do not charge damaged battery packs.
s
Do not expose to water.
t
Have defective cords replaced immediately
u
Charge only between 4 ˚C and 40 ˚C.
WALT battery pack will be
e
WALT
e
v
Only for indoor use.
x
Discard the battery pack with due care for
the environment.
y
Charge D
WALT battery packs only with designated
e
D
WALT chargers. Charging battery packs other than
e
the designated D
e
charger may make them burst or lead to other
dangerous situations.
z
Do not incinerate the battery pack.
Battery Type
The following tools operate on a 12 volt battery pack: DCD716 .
These battery packs may be used: DCB122, DCB124, DCB124G,
DCB125, DCB126, DCB126G, DCB127. Refer to Technical Data
for more information.

Package Contents

The package contains:
1 Drill/driver/hammerdrill
1 Charger
1 Li-Ion battery pack (C1, D1, E1, L1, M1, P1, S1, T1, X1, Y1 models)
2 Li-Ion battery packs (C2, D2, E2, L2, M2, P2, S2, T2, X2, Y2 models)
3 Li-Ion battery packs (C3, D3, E3, L3, M3, P3, S3, T3, X3, Y3 models)
1 Instruction manual
nOTE: Battery packs, chargers and kitboxes are not included
with N models. Battery packs and chargers are not included with
NT models. B models include Bluetooth® battery packs.
nOTE: The Bluetooth® word mark and logos are registered
trademarks owned by the Bluetooth®, SIG, Inc. and any use of
such marks by D
WALT is under license. Other trademarks and
e
trade names are those of their respective owners.
Check for damage to the tool, parts or accessories which may
have occurred during transport.
Take the time to thoroughly read and understand this manual
prior to operation.

Markings on Tool

The following pictograms are shown on the tool:
Read instruction manual before use.
Visible radiation. Do not stare into light.
Date Code Position (Fig. B)
 16 
The date code
, which also includes the year of manufacture,
is printed into the housing.
Example:
2021 XX XX
Year and Week of Manufacture
WALT batteries with a D
WALT
e
English
9

Advertisement

Table of Contents
loading

Table of Contents