Eco Mode; Barista Mode; Latte Mode; Party Mode - Miele CVA 7370 Operating And Installation Instructions

Built-in coffee system
Table of Contents

Advertisement

Settings

Eco Mode

Eco Mode is an energy-saving mode.
The system does not heat up until
someone starts making a drink.

Barista Mode

This Performance Mode has been
optimized for unadulterated coffee
enjoyment. Users can enjoy coffee-
based drinks without any delay as the
coffee machine remains heated to the
brewing temperature. This mode
consumes more energy than Eco Mode.

Latte Mode

This Performance Mode has been
optimized for preparing milk. Milk-
based drinks can be prepared within a
much shorter space of time. This mode
consumes more energy than Eco Mode
and Barista Mode.

Party Mode

This Performance Mode has been
configured for the occasional intensive
use of the coffee machine, e.g., for
family get-togethers.
Clean the coffee machine thoroughly
after intensive use, particularly the
milk pipework. It may be necessary
to descale the coffee machine and
degrease the brew unit.
Please note the following information
about Party Mode:
- The general pipework is rinsed much
less frequently or not at all. The milk
pipework is not rinsed until
around 1 hour after milk was last
dispensed.
46
- Cleaning status messages or
cleaning prompts are suppressed
and delayed until the machine is next
switched on.
- The
Turn off at
are deactivated. The coffee machine
switches off 6 hours after the last
sensor button was pressed.
- The cup light remains permanently
switched on at the maximum
brightness level for as long as the
coffee machine stays switched on.

Water hardness

Program the coffee machine to the
water hardness level of your area so
that it functions correctly and does not
get damaged.
Your local water authority will be able to
tell you the hardness of the water in
your area.
If you are using bottled drinking water,
e.g., mineral water, select settings
according to the calcium content. The
calcium content is given on the label of
the bottle in mg/l Ca
2+
Ca
/l).
Do not use carbonated water.
The hardness level is set to 21.8 gpg
(21°dH) by default.
and
timers
Turn off after
2+
or ppm (mg

Advertisement

Table of Contents
loading

Table of Contents