Risk Reduction; Know Your Product; Maintenance - Ryobi R18TR Original Instructions Manual

– Wear appropriate dust mask with suitable filters that
can protect against particles from the material of the
workpiece. Do not eat, drink, or smoke in the work
area. Ensure adequate ventilation and use the dust
extraction accessories provided.
■
Injury from contact with the cutting bits
– The bits are sharp and will become hot during use.
Wear gloves when changing bits. Keep hands away
from the cutting area at all times. Never hold the
workpiece being cut in your hands or across your
leg. Secure the workpiece whenever possible.

RISK REDUCTION

It has been reported that vibrations from handheld tools
may contribute to a condition called Raynaud's Syndrome
in certain individuals. Symptoms may include tingling,
numbness, and blanching of the fi ngers, usually apparent
upon exposure to cold. Hereditary factors, exposure to
cold and dampness, diet, smoking, and work practices
are all thought to contribute to the development of these
symptoms. There are measures that can be taken by the
operator to possibly reduce the effects of vibration:
■
Keep your body warm in cold weather. When operating
the product, wear gloves to keep the hands and wrists
warm. It is reported that cold weather is a major factor
contributing to Raynaud's Syndrome.
■
After each period of operation, exercise to increase
blood circulation.
■
Take frequent work breaks. Limit the amount of
exposure per day.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor about
these symptoms.
WARNING
Injuries may be caused or aggravated by prolonged use
of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.
ASSEMBLY
WARNING
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
WARNING
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modifi cation is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
2 | English

KNOW YOUR PRODUCT

See page 87.
1. On/off switch
2. Battery port
3. Zero reset
4. Micro depth adjustment knob
5. Motor housing
6. Depth scale
7. Removable base
8. Motor release lever
9. Quick release lever
10. Spindle lock
11. 6.35 mm collet
12. Collet nut
13. Square subbase
14. Wrench
15. 6 mm collet
16. Straight bit
17. Guide bars
18. Edge guide

MAINTENANCE

The product should never be connected to a power supply
when you are assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product will prevent
accidental starting that could cause serious injury.
■
When servicing, use only original manufacturer's
replacement parts. Use of any other parts may create a
hazard or cause product damage.
For greater safety and reliability, all repairs should be
performed by an authorised Ryobi service centre.
GENERAL
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
Do not, at any time, let brake fl uids, gasoline, petroleum-
based products, and penetrating oils, come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
The dust from plaster and wall board is abrasive and
may cause premature failure of the product if it is allowed
to enter the motor area. Always use the dust extraction
accessory connected to a vacuum. Thoroughly clean the
product after use by using a brush and a vacuum. Take
care not to push dirt into the ventilation openings. Beware
of using compressed air to clean the product because dust
and grit can cause serious eye injury.
Autogoods "130"
WARNING
WARNING
WARNING