PMC manufactured accessories delivered with the equipment (hereinafter “Product”) against defects in material or workmanship of the Product (hereinafter “Defect” or “Defective”) for a period of one (1) year from the date of first purchase as shown on the original PMC invoice (hereinafter “Warranty Period”).
Page 4
No Rights Implied: Nothing in the sale, lease or rental of any Product by PMC shall be construed to grant any right, interest or license in or under any patent, trademark, copyright, trade secret or other proprietary right or material owned by anyone;...
Keep this Operations Manual for future consultation of useful information at all times. If you lose this manual, ask for a new copy from your PMC Distributor or go online and visit our web site at www.polymacusa.com.
Page 6
The TSU has been designed and built for the application of polyurea chemical systems, polyurethane foam chemical systems, and some two-component epoxy systems. Always use liquids and solvents that are compatible with the unit. If in doubt, consult your PMC Distributor.
EL-51A-4 CHARACTERISTICS CHARACTERISTICS Accurate and precise Compact design Easy to install Low maintenance TECHNICAL SPECIFICATIONS Thermocouple Type ....................Type E Temperature Range ...............0 to 1000 F (-18 to 540 “A” Side Fittings ....................... -5 JIC “R” Side Fittings ....................... -6 JIC Air Fittings......................
EL-51A-4 DESCRIPTION DESCRIPTION A. Thermocouple Connector B. Flexible Metal Conduit C. “A” Side Inlet Fitting D. “A” Side Outlet Fitting E. Sensing Wire F. “R” Side Inlet Fitting G. TSU Body H. “R” Side Outlet Fitting I. Air Inlet Fitting J.
EL-51A-4 INSTALLATION INSTALLATION CAUTION! Connecting the TSU between the first and second section of Heated Hose results in the TSU sensing the material temperature exiting the Heater and not the inside of the Heated Hose near the Spray Gun. CAUTION! To protect the TSU sensor, pay special attention not to kink or excessively bend the Heated Hoses.
This chapter contains information on possible faults that may interrupt the operation of the TSU. The information provided will serve as a guideline to detect and resolve problems. In any case, feel free to contact your authorized PMC Distributor, where a qualified technician will advise you.
Page 11
EL-51A-4 TROUBLESHOOTING PROBLEM Hose does not heat and the display on the controller shows a flashing error message: “EEEE” on the Auber controller, “SbEr” on the Eaton controller, or “S.ERR” on the Omron controller. SOLUTIONS 1. Check the thermocouple terminals (TC+ and TC-) on the heater controller for loose wires and improper connections.
EL-51A-4 PARTS IDENTIFICATION PARTS IDENTIFICATION EL-51A-4 ITEM PART NUMBER DESCRIPTION EL-51A-2 FLEX THERMOCOUPLE EL-00051A-3 1/8 X #4 JIC FEM SWIVEL FTG EL-00051A-4 1/4 X #5 JIC MALE FTG EL-00051A-5 1/4 X #6 JIC FEMALE SWIVEL FTG EL-00051A-6 1/4 X #6 JIC MALE FTG...
EL-51A-4 MANUAL REVISIONS MANUAL REVISIONS Revision Date Changes Approved 09-01-2015 Initial release of EL-51A-4 Manual. Vadams Change position of the page number 09-15-2017 from bottom center to bottom right. Updated TSU construction and pictures 04-02-2019 consistent with ECO 10095. Rev 1.2, 4/2/19...