Adjustment Method - Panasonic TX-32LX60F Service Manual

Adjustment Method

How to enter Service 1
•
Set the Bass to maximum position, set the Treble to minimum position then keep pressing the INDEX button on the
remote control and press the down button (-/v) on the TV set, this will place the TV set into the Service Mode 1.
Key Command
•
Press the RED / GREEN buttons to step up / down through the functions.
•
Press the YELLOW / BLUE buttons to alter the function values, to alter White Rasters use +/- buttons
•
Press the OK button after each adjustment has been made to store the required values.
•
To exit the Service Mode, press the "N" button.
Keep adjusting sequence: DVCO, Sub-Contrast, other items.
Item
Note: All setting values are approximate
Sub-Contrast
DVCO
Highlight High
Lowlight
Low
Sub-Brightness
White Balance Adjustment
Instrument
•
Remote Control
•
LCD WB meter (Minolta CA-210 or equivalent)
Condition
•
Switch on the TV Set. Enter Service1. Step down to Highlight line and keep the aging time more than 20 minutes.
Procedure
•
After aging time above set White Raster No.12 for Highlight and No.4 for Lowlight
to store.
•
Put Minolta Sensor to the center of the LCD Panel with 25mm gap between Minolta Sensor and LCD Panel. Adjust "x"
and "y" values by changing Red and Blue values.
•
Press OK button to store setting.
All manuals and user guides at all-guides.com
Setting indication
Sub-Contrast
23
DVCO
4
12 0415 0410 0425
4 0056 0064 0043
Sub-Brightness
0
Item
Highlight
Lowlight
9
Settings / Special features
Receive a 80% white level Philips Pattern with correct
sound system (B/G, D/K) via aerial input. For Sub-
Contrast alignment press "Blue" button, wait until the
figure colour is changed from red to black colour.
Press the OK.
Receive a 80% white level Philips Pattern via aerial
input. For DVCO alignment press "Blue" button, wait
until the figure colour is changed from red to black
colour. Press the OK.
For correct setting see White Balance Adjustment
Optimum setting.
High
Low
Value
x
0,275±0,005
y
0,275±0,005
x
0,275±0,005
y
0,285±0,005
12
Press the OK button
4