Din Rear-Mount; Fixing The Front Panel - Pioneer DEH-P6600 Operation Manual

DIN Rear-mount

Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 8)
2. Fastening the unit to the factory radio mounting bracket.
(Fig. 9) (Fig. 10)
Select a position where the screw holes of the bracket and
the screw holes of the head unit become aligned (are fitted),
and tighten the screws at 2 places on each side. Use either
truss screws (5 × 8 mm) or flush surface screws
(5 × 9 mm), depending on the shape of the screw holes in
.
the bracket
10
Factory radio mounting bracket
12
Frame
Insert the release pin into the hole in
the bottom of the frame and pull out
to remove the frame.
(When reattaching the frame, point
the side with a groove downwards
and attach it.)
Screw
11
Dashboard or Console
13

Fixing the front panel

If you do not operate the removing and attaching the front panel function, use the supplied
fixing screws and holders to fix the front panel to this unit.
1. Attach the holders to both sides of the front panel. (Fig. 11)
2. Replace the front panel to the unit. (Fig. 12)
Fig. 8
3. Flip the holders into upright positions. (Fig. 13)
Fig. 9
4. Fix the front panel to the unit using fixing screws. (Fig. 14)
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fixing screw
Fig. 14