Care & Cleaning - Frigidaire Warm Drawer Use And Care Manual

Surfaces
Vinyl
Plastic
Control Knobs, Control Panel
Stainless Steel
Drawer, Body Parts and Drawer
Cavity
Porcelain Enamel
Drawer Liner, Body Parts and
Drawer Cavity
Warmer Drawer Rack
Turn the warmer drawer
control knob to OFF before removing the
drawer. DO NOT touch the warmer
drawer element. The element may still
be hot enough to cause burns, even if it
is dark in color.
Latch
Left Glide
Latch
Push down latch
with finger
Warmer Drawer
Care & Cleaning
How to Clean
Use hot, soapy water and a cloth. Dry with a clean cloth.
To remove control knob, turn to the OFF position; grasp firmly and pull straight off the
shaft. Clean with a cloth soaked in soapy water. Rinse with a clean water and a dishcloth.
Be sure to squeeze excess water from the cloth before wiping the panel; especially when
wiping around the controls. Excess water in or around the controls may cause damage
to the appliance. To replace knob after cleaning, line up the flat sides of both the knob
and the shaft; then push the knob into place.
Cleaners made especially for stainless steel are recommended. Always follow the
manufacturer's instructions. Be sure to rinse the cleaners. Do not use cleaners with
high concentrations of chlorides or chlorines. Do not use harsh scrubbing cleaners.
DO NOT clean the door gasket. The door gasket is essential for a good seal. Care should
be taken not to rub, damage or remove the gasket.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1
solution of clear water and ammonia. If necessary , cover difficult spots with an ammonia-
soaked paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth, and
then scrub with a soap-filled scouring pad. Rinse and wipe dry with a clean cloth. Remove
all cleaners or the porcelain may become damaged during future heating. DO NOT use
spray oven cleaners.
The rack may be removed for cleaning. Clean by using a mild, abrasive cleaner following
manufacturer's instructions. Rinse with clean water and dry.
To Remove and Replace Warmer Drawer
To Remove Warmer Drawer:
1.
2. Open the drawer to the fully opened position.
3. Locate the latches on both sides of the warmer drawer.
4. Pull up on the left glide latch and push down on the right glide latch.
5. Pull the drawer away from the appliance.
6. To clean warmer drawer, gently scour with a soapy scouring pad, this will
remove most spots. Rinse with a 1:1 solution of clear water and ammonia. If
necessary, cover difficult spots with an ammonia-soaked paper towel for 30
to 40 minutes. Rinse with clean water and a damp cloth. Remove all cleaners
or the porcelain may become damaged during future heating. DO NOT use
Pull up latch
spray oven cleaners on the cooktop.
with finger
To Replace Warmer Drawer:
1. Align the glide latches on both sides of the drawer with the slots on the drawer.
2. Push the drawer back into the appliance.
Right Glide
Turn power off before removing the warmer drawer.
Electrical Shock Hazard can occur and result
in serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
6