Setup For First Time Use; Installing The Software - Silvercrest VG 2000 User Manual And Service Information

SilverCrest USB 2.0 Video Grabber VG 2000

Setup for first time use

Installing the software

The required software (drivers and applications) must first be
installed before you plug in the device.
When installing programs or drivers important files can be
overwritten and altered. You should back up the contents of your
hard drive before the installation of the programs, so that you can
still access your original files if there is a problem with the
installation.
Should your operating system be set in a way that the installation
of software and drivers will only be accepted when they are signed
(approved by Microsoft), an appropriate dialogue box will appear.
This does not mean that the driver is defective, just that it is
indicating that it does not have this Microsoft signature. You can
ignore this advice. Click on 'Continue' to install the drivers.
• Insert the enclosed CD ROM in the drive and the installation will start
automatically.
• Install the software (Power Director) and the drivers (Device Driver)
according to the directions on the screen.
• Restart your PC after installation to finalise the procedure.
− Click on the 'Start' button to open the Start Menu.
− Click on the option 'Run...'
− Insert the drive letter of your CD ROM drive, followed by a colon and the
program name 'Autorun' (e.g. D:autorun)
− Click on the 'OK' button to confirm the action.
A description of the software can be found on the CD ROM.
If the installation assistant does not automatically start when
the CD ROM is inserted, then the auto run function of your
CD drive is deactivated. Then proceed as follows:
English
7