Advertisement
Quick Links
- IMPORTANT -
THIS MACHINE IS NOT TO
BE OPERATED BY ANYONE
UNTIL HAVING CAREFULLY
READ THIS INSTRUCTION
BOOK ON ITS USE.
IF ANYONE ELSE THAN THE
ORIGINAL BUYER OF OUR
EQUIPMENT IS TO USE THE
MACHINE, THEN HE or SHE
IS TO BE FURNISHED WITH
AN INSTRUCTION BOOK.
Replacement manuals are
available online at mytana.com/
product-manuals
M81 shown with optional
cable, reel and rev arm.
Autofeed (not shown) is
optional
022222
Manufacturers of Quality
Sewer & Drain Cleaning
Equipment since 1957
M81 Owners Manual
Please inspect your machine carefully upon receipt.
Let us know immediately if you note any damage.
www.MyTana.com
746 Selby Ave • St. Paul, MN 55104
fax: (651) 222-1739
M81 base unit: no cable,
reel or rev arm
(800) 328-8170
Factory Direct Customer Service
M –F 7am – 5pm CST
Competent • Polite • Clear
Advertisement
Related Manuals for MyTana M81
Summary of Contents for MyTana M81
- Page 1 Let us know immediately if you note any damage. - IMPORTANT - THIS MACHINE IS NOT TO BE OPERATED BY ANYONE M81 base unit: no cable, UNTIL HAVING CAREFULLY reel or rev arm READ THIS INSTRUCTION BOOK ON ITS USE.
- Page 2 Install wheel axle kit Make sure that the M81 is on a level surface or work- bench so that the axle kit is installed properly and evenly. Mount reel onto machine Grasp the reel firmly and lift it up so that the back center of the hub aligns with the main drive shaft.
-
Page 3: Foot Pedal
Autofeed slips under it just reaches the front opening (see below). the flange on the front M81 head casting. Secure into place by threading the top two... -
Page 4: Operation
PG 4 MyTana M81 CABLE MACHINE User Manual ALL OPERATORS: Read the operating instructions on the these pages before operating equipment. u BEFORE STARTING your u SHUT OFF THE MOTOR u SAFETY Operators should wear first job – Read the paragraph WHEN NOT IN USE –... - Page 5 PG 5 MyTana M81 CABLE MACHINE User Manual As you operate the machine, place one hand on the cable Figure 4 close to the switch or Autofeed (figure 4 ) to prevent any throwing of the cable. Gently pull the cable out of the machine a little at a time.
- Page 6 Changing Reels If the line is longer than the amount of cable you have on the reel, MyTana makes it easy to swap in a new reel so you can push farther, see below. When back end (anchor) cable...
-
Page 7: Maintenance And Tips
Push the reset button back in to restore power. dramatically. MyTana’s MT21 is a water based treatment that also deodorizes. You can also hose down the cable Extend the life of your pneumatic foot pedal (remove reel from machine first) and spray it with WD40 or any light oil. - Page 8 Vinyl grips S-100 casting Front bushing – steel Rear bushing – S100A brass MyTana stocks replacement parts for S100B the M81. Many are available online at mytana.com/cable-machine-parts www.MyTana.com (800) 328-8170 746 Selby Ave St. Paul, MN 55104 fax: (651) 222-1739...
Need help?
Do you have a question about the M81 and is the answer not in the manual?
Questions and answers