Hide thumbs Also See for M20:

Advertisement

Quick Links

-IMPORTANT-
FOR YOUR SAFETY, AND
TO ENABLE MAXIMUM
EFFECTIVENESS OF YOUR
EQUIPMENT, READ
(AND UNDERSTAND) THIS
INSTRUCTION MANUAL
ENTIRELY BEFORE USING
YOUR HIGH-PRESSURE
WATER JETTING UNIT
FAILURE TO FOLLOW
INSTRUCTIONS AND
REGULATIONS CONTAINED IN
THIS MANUAL CAN RESULT
IN SERIOUS INJURY TO THE
OPERATOR AND/OR TO
ANYONE IN CLOSE PROXIMITY
TO THE WORK AREA.
042622
Manufacturers of Quality
Sewer & Drain Cleaning
Equipment since 1957
User Guide for
M20 or M20T Jetters
The pump/motor unit may be removed
from the cart on the M20 model.
The cart holds our Large
Hose Reel as shown.
The M20T is the pump/motor unit only, no cart or reel.
www.MyTana.com
746 Selby Ave • St. Paul, MN 55104
fax: (651) 222-1739
M20
shown with
optional hose
and reel
M20T
(800) 328-8170
Factory Direct Customer Service
M –F 7am – 5pm CST
Competent • Polite • Clear

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the M20 and is the answer not in the manual?

Questions and answers

Summary of Contents for MyTana M20

  • Page 1 User Guide for M20 or M20T Jetters The pump/motor unit may be removed from the cart on the M20 model. -IMPORTANT- The cart holds our Large Hose Reel as shown. FOR YOUR SAFETY, AND TO ENABLE MAXIMUM EFFECTIVENESS OF YOUR...
  • Page 2 MyTana stocks replacement parts for our • If an extension cord is needed beyond the built-in 25’ jetters. Many are available to purchase cord, use 12gauge or heavier to power the M20 online at mytana.com/jetter-parts • Avoid getting the electrical connections and components wet.
  • Page 3 Additionally, refer to the motor’s manual as outlined on page 5. for details and care of the motor. M20 The motor/pump unit may be removed from the cart. Pull out the lock-pin and lift the unit off the frame. Large Hose Reel...
  • Page 4 See instructions on page 6 for antifreeze procedure. Water temperatures in excess of 140° can damage the u If the M20 will not be used for more than 2-3 days, pump seals. The thermal relief valve provides protection even in warm temperatures, we recommend running when the pump goes into “bypass”, meaning the pump is...
  • Page 5 3. M20 Hose on reel is ready to go. If using smaller • When operating from the high end to low end (most trap hose, disconnect jumper hose at the pump, and common) shut off the water flow ball valve on the reel connect the 1/8”...
  • Page 6 PG 6 MyTana M20T / M20 JE T TER User Manual Troubleshooting Problem Probable Cause Solution Worn nozzle Replace nozzle Oversized nozzle Attache correct nozzle Pulling air at inlet line Disassemble, reseal and reassemble Low Water Pressure Inlet strainer clogged...
  • Page 7 MyTana has a TigerTail that helps hook up to your water source. Antifreeze can be used protect your hose, available at MyTana.com.
  • Page 8 If jetter will be unused for 2-3 days Recommended: RV antifreeze. Keep machine clean and dry to maximize performance and longevity. (800) 328-8170 MyTana.com mytana@mytana.com youtube.com/videoMyTana EMAIL M–F 7a to 5p CST MYTANA LLC 746 SELBY AVE • ST. PAUL, MN 55104...

This manual is also suitable for:

M20t

Table of Contents