Opening The Front Door Panel For Electrical Hookup - Cal Spas LES Owner's Manual

2.4 Opening the Front Door Panel for Electrical Hookup

2.4 Opening the Front Door Panel for Electrical Hookup
NOTE: The following electrical connections must be performed by a licensed electrical contractor.
Unscrew and remove the two corner panels on each side of the spa's front door.
Reach in and pull the drain assembly through by a few inches. Carefully unscrew the black outer drain knob and
then unscrew and remove the front door panel.
Pictured above is the inside of the spa behind the front door. The electrician now has access to connect the
spa for power. While the front door is off, refer to page 11 for instructions on ensuring the plumbing fittings are
secure (but do not be tempted to over-torque or over-tighten these fittings).
Pull the drain pipe through the front door panel, reattach the black outer drain knob and pull the drain
assembly back inside so that the knob is flush with the panel again. Reattach and screw panels back in. (Front
door first, then corner panels)
7