Fisher SRC-850A Instruction Manual page 16

VIDEO CASSETTE TAPES
Correct tape thread check function
This function checks to make sure that the cassette has
been correctly loaded so that recording can be carried
out.
NOTES:
œ After the cassette tape is loaded, the mechanism will
operate for about 5 seconds to check that the tape
has been threaded (loaded) correctly automatically
and the cassette indicator "o" will flash during that
period. If the tape is not loaded properly, the cassette
will be ejected.
œ If the REC, PLAY, FF, REW or STOP button is
pressed during the tape thread check operation, the
command will only be executed after the tape thread
has been checked. Only the EJECT button will
operate while the tape thread is being checked.
œ If "TAPE IN MODE" in the (GENERAL SET) menu is
set to "REC", the recording indicator "a" will light while
the tape thread is being checked. However, recording
will only start after the tape thread check is completed.
1
Press the MENU button to display the MAIN MENU.
2
Press the l (or j) button to select the "4.GENERAL
SET" line, then press the ENTER button.
ø The (GENERAL SET) menu appears.
<GENERAL@SET>
TAPE@IN@MODE@@@@@STOP
TAPE@END@MODE@@@@REW
CLOCK@ADJUST@@@@@01:00
THREAD@CHECK@@@@@N
VIDEO@LOSS@@@@@@@N
REMOTE@@@@@@@@@@@MENU
VIDEO@@@@@@@@@@@@COLOR
3
Press the l (or j) button until the "THREAD
CHECK" setting is highlighted, then press the
ENTER button.
4
Press the l (or j) button to select the desired
mode, then press the ENTER button.
N . . . . . . . . . The correct tape thread check
function is off
Y. . . . . . . . . . The correct tape thread check
function is on
5
Press the MENU EXIT button.
English
Setting the Action to Take When a
Cassette is Loaded
You can set the mode the VCR will go into when a
cassette is loaded.
1
Press the MENU button to display the MAIN MENU.
2
Press the l (or j) button to select the "4.GENERAL
SET" line, then press the ENTER button.
ø The (GENERAL SET) menu appears.
3
Press the l (or j) button until the "TAPE IN MODE"
setting is highlighted, then press the ENTER button.
4
Press the l (or j) button to select the desired mode,
then press the ENTER button.
STOP . . . . . . When tape inserted the VCR,
REC . . . . . . . When tape inserted the VCR,
5
Press the MENU EXIT button.
15
stays in stop mode
goes into recording mode