User Instructions; Operation - Easy@Home HF3102A-UL User Manual

User instructions

User instructions
NOTICE!
Before each use
CHECK HUMIDIFIER PLACEMENT – Place the Humidifier on a non-
metallic, lint free, waterproof, level surface for best performance.
This is to help disperse the mist in the air and prevent it from being
knocked or tipped over.
CAUTION!
DO NOT operate the humidifier without water in the water tank.
DO NOT plug in the power supply cord with wet hands; electric
shock could happen.
− Be sure the humidifier is turned OFF and the humidifier is
unplugged from the electrical outlet.
− Select a location for your humidifier on a flat surface
approximately 4 inches away from a wall.
− DO NOT place the humidifier on a finished floor or near
furniture which can be damaged by moisture or water. Place
on a water resistant surface.
− DO NOT place humidifier on top of a towel, or a carpeted
surface. This may cause the humidifier to overheat.
− DO NOT place humidifier on a wood surface.
− A short power supply cord is provided to reduce the risk of
personal injury resulting from becoming entangled in or
tripping over a longer cord.
− To avoid a circuit overload when using this humidifier, do not
operate another high-wattage product on the same electrical
circuit.
− Avoid the use of an extension cord because the extension cord
may overheat and cause a risk of fire. However, if you have to
14
use an extension cord, the extension cord should be rated for
13 amps, 125V, 1625 watts.
− The power supply cord must be arranged so that it will not
drape over the countertop or tabletop where it can be pulled
on by children or tripped over accidentally.

Operation

1. Lift water tank (p. 3, fig. A 9 ) off of base holding bottom of tank with both
hands.
2. NOTE: DO NOT hold water tank by handle when empty or full.
3. Turn tank upside down and unscrew water tank cap (p. 3, fig. A
counterclockwise.
4. Fill water tank with cold water. Do not fill all the way to the rim.
5. NOTE: If you have hard water, it is recommended to use filtered or distilled water.
While using the humidifier, if you see a film of white dust, it is because of hard
water.
6. DO NOT add any medication or other additives into the water tank itself. For use of
essential oils, see page 17.
7. Screw water tank cap (p. 4, fig. E
8. Place tank onto the base (p. 4, fig. F
There should not be a space between the tank and base.
9. Place mist lid on top of water tank.
10. NOTE: DO NOT move humidifier while water tank is on base. Water may leak into
the base causing a malfunction.
11. Plug the power cord into an electrical outlet. DO NOT use an extension cord.
12. Turn power on by turning the control knob (p. 3, fig. A
right). You will hear a minor clicking noise when turning unit on and off. The
green power indicator light (p. 3, fig. A
10 ) by turning it
10 ) back onto tank by turning clockwise.
2 ). Make sure it is laying flush into the base.
6 ) clockwise (to the
7 ) will turn on.
Operation
15