How To Use; How To Charge - iClever IC-OD45B User Manual

Portable power station

Table of Contents

HOW TO USE

There is a charging port on the iClever IC-OD45B, that is, the DC input port on the back

of the product, which can meet the voltage requirement of the 12-25V power adapter,

the 12V car (24V car charging is not supported) and the output voltage of 12-25V solar

panel charging.

When the charging mode starts, the highest digit of the battery level will flash, and all

the battery levels will light up. If no battery level flashes, the power is fully charged.

The energy storage power supply supports both charging and discharging.

If you need to use while charging (under the condition of the adapter charging), the

product will be slowly fully charged according to the internal battery capacity if the

output power is less than 100W; the product will slowly use up the internal battery

capacity if the output power is greater than 100W, and the product can be used

normally after it is fully charged.

The product has a charging protection function. Use it according to the normal charging

operation. After the product is fully charged, it will automatically stop charging. In order

to avoid other accidents, unplug the product immediately when it is fully charged.

1.1 Solar Charging

Insert the plug of the unfolded solar panel into the "input" interface of the DC input

port on the back of the product. Then the last cell of the battery icon will flash, and the

remaining time of full charge will be displayed at the same time. The power of the solar

panel is greatly affected by the light. If the generated power changes, the remaining

time will change dynamically, which is normal.

1.2 Adapter Charging

● Insert the AC input plug of the adapter into the electric supply.

● Insert the adapter DC output plug into the "input" interface of the DC input port on

the back of the product. Then the last cell of the battery icon will flash, and the

remaining time of full charge will be displayed at the same time. The system will

automatically detect the input power when charging, and the remaining time will

dynamically change, which is normal.

1.3 Cigarette Lighter Charging

● Start the car.

● Insert the head of the "car charger to DC cable" into the car cigarette lighter.

● Insert the DC head into the "input" interface of the DC input port on the back of the

product. Then the battery icon will scroll to show the battery level, and the remaining

time of full charge will be displayed at the same time.

Table of Contents