Honda GXE2.0H Manual page 65

dummyhead dummyhead
Parts
[1] BOLT (5 x 16 mm) (2)
[2] AIR DUCT
[3] NUT (12 mm)
[4] COOLING FAN
[5] WOODRUFF KEY (13 x 12 mm)
[6] BOLT (6 x 50 mm) (8)
[7] MOTOR HOUSING (FAN SIDE)
[8] DOWEL PIN (2)
[9] HOUSING PACKING
[10] ROTOR/SHAFT
[11] BOLT (5 x 12 mm) (4)
[12] ROTOR FAN
[13] SOCKET BOLT (6 x 16 mm) (4)
[14] MOTOR HARNESS STAY (2)
[15] SOCKET BOLT (6 x 40 mm) (3)
[16] STATOR ASSEMBLY
[17] MOTOR HOUSING (P.T.O. SIDE)
COOLING FAN REMOVAL/INSTALLATION
TOOL FITTING
Place the motor assembly on wooden blocks [1] and install the special tool.
– [2] Tool: Cooling fan holder (070PB-8A00100)
NOTE: There are three pins [3] on the special tool that allows gaps between
the pins and the holes [4] in the fan so that they contact evenly.
The four 6 mm bolts of the special tool are tightened to 12 N·m (1.2 kgf·m, 9
lbf·ft).
REMOVAL/INSTALLATION
Holding the special tool with a breaker bar [1], loosen the 12 mm nut [2],
and then remove the cooling fan [3].
Installation is in the reverse order of removal.
TORQUE: 12 mm nut: 59 N·m (6.0 kgf·m, 44 lbf·ft)
TOOL: COOLING FAN HOLDER (070PB-8A00100) (page 7-7)
INSPECTION: Check the dust seal and bearing in the housing for wear or damage.
TOOL: ROTOR GUIDE (070PG-8A00100) (page 7-8)
INSPECTION: Check for damage in the stator coils (page 2-7).
INSTALLATION: Set the wires in the grommets properly and install them into the
housing grooves tightly (page 2-7).
INSPECTION: Check the dust seal and bearing in the housing for wear or damage.
Remarks
[2]
[2]
[3]
POWER UNIT
[3]
[4]
[1]
[1]
7-7