Advertisement
FIGURE 2
I
O
NSTALLING THE
SCILLOSCOPE
P
S
UTTING THE
COPE IN THE
1. Remove the four black screws from the scope's left and right side surfaces with the
Torx L-Key (Item #11) as shown in Figure 2.
2. Insert the nylon washer (Item #9) onto the hex standoff thread (Item #8) and screw
the standoffs into the four mounting locations where the four black screws were
removed as shown in Figure 3.
3. Place the scope on the rackmount base and align the standoffs to the side panel holes.
Screw the four pan head screws (Item #10) into the standoffs (Item #8) to lock the
scope into place as shown in Figure 3.
A
I
DDITIONAL
NFORMATION
Warning: The front panel of the rackmount assembly includes eight holes to secure the
assembly to the rack. The front panel must be secured to the rack to prevent potential injury.
Rackmount: The rackmount should only be used with a LeCroy WaveRunner 6000 Series
Oscilloscope. LeCroy assumes no responsibility if the rackmount is used with another scope.
Max DSO Dimensions (HxWxD):
8.5" x 13.8" x 14.4" (excluding feet) 216mm x 351mm x 366mm
Rackmount Dimensions (HxWxD):
8.72" x 18.98" x 14.52", 221.5mm x 482.1mm x 368.8mm
O
I
RDERING
NFORMATION
WR6-RACK2
R
ACKMOUNT
FIGURE 3
Copyright © March 2004
LeCroy is a registered trademark
of LeCroy Corporation. All rights
reserved. Information in this
publication supersedes all earlier
versions. Specifications subject to
change without notice.
902253-00 Rev.A
Advertisement
