Page 1
LeCroy 5U Rackmount Kit for the 6000 series...
Page 2
ITEM # QTY. DESCRIPTION RUBBER BUMPER #4-40 x .312" FLAT HEAD SCREW T15 TORX L-KEY #6-32 x .250" PAN HEAD SCREW NYLON WASHER #6-32 x .500" HEX STANDOFF #6-32 x .375" FLAT HEAD SCREW M5 x 12mm PAN HEAD SCREW HANDLE RACKMOUNT FRONT PLATE RACKMOUNT RIGHT SIDE...
Page 3
FIGURE 1 ACKMOUNT SSEMBLY NSTRUCTIONS 1. Assemble the handles (Item #5) to the front plate (Item # 4) using four pan head screws (Item #6). Note: Place handle on the side with the seven countersink holes. 2. Assemble the rackmount kit by mounting the base plate (Item #1) to the front plate (Item #4) using two #6 flat head screws (Item #7) and two #4 flat head screws (Item #12).
Page 4
The front panel must be secured to the rack to prevent potential injury. Rackmount: The rackmount should only be used with a LeCroy WaveRunner 6000 Series Oscilloscope. LeCroy assumes no responsibility if the rackmount is used with another scope.