Durite 0-649-27 Quick Start Manual

Mini Jump Pack for 12VDC Vehicles
Part 0-649-27

How to jump start a car?

Connecting the jumper cable's Positive
clamp to the vehicle battery positive
terminal, and the Negative clamp to
the battery negative terminal.
The LED shall turn into solid green automatically, then you can move on to the 4th step.( Note: If the LED light is not
solid GREEN, 1. Please check if the product is over 50% power, also please check if the clamps were not reverse
connected. Otherwise, you need to activate the "Force to jumpstart mode" by holding the side button for 3 seconds,
then you shall see the LED light turn into solid GREEN, you can move to the 4th step at this moment.
Turn the ignition key to jumpstart

How to switch between 12V, 16V, or 19V ?

ON/OFF
Slide the master switch to "ON" Press to switch 12V, 16V or
position.
19V.
Insert the jumper cable to the product's
jumpstart port.
Remove the jumper cable from
the product.
%
12V 16V 19V
0-649-27-LEAFL

How to charge a laptop?

Connect the charging cable to Choose the suitable connector.
the DC output port.

How to charge a cellphone?

Connecting the USB charging Connecting the cable with
cable to the USB output port. cellphone.

How to turn on the LED torch light/SOS/strobe mode?

ON/OFF
Slide the master switch to
"ON" position.

How to recharge the product?

Connecting the charging pin
to the product's input port.
7
Third step:
Connecting the cable with the
connector, then insert it to
laptop's charging input port.
Third step:
Press
Hold for 3 seconds to turn on LED
torch light, press 1 time to switch to
SOS mode, press 1 time to switch to
strobe mode.
Plug-in the AC adapter to the wall
socket. Or you can use the 12V car
charger to recharge the product in
your car.
0-649-27-LEAFL