Extron electronics IPI 200 Series User Manual page 17

2. Locate the small corner notch on the lens cap and slide
the screwdriver between the lens cap and the diffuser, as
Ç
shown in
Using a rotating motion of the screwdriver (see
carefully pry the two pieces apart.
3. Replace the label with the new button label.
4. Press the lens cap and diffuser together and reinstall the
button assembly into its plunger/base.
Repeat steps 1 through 4 for each button you plan to re-
5.
label.
Clear Lens
Separating the two-
piece button here at
the corner.
IPI 100 Series, IPI 200 Series • Installation
.
É
Pry the two
Ç
pieces apart.
Notch
Plunger
T E
X T
Diffuser
Button Label
É
),
Base
2-3