iOptron AZ Mount Pro Assembly

iOptron AZ Mount Pro Assembly

Binocular adapter
Hide thumbs Also See for AZ Mount Pro:

Advertisement

Tool Needed: A set of metric Allen wrench

Parts Included:

1. Tighten locking knob
2. Remove hand controller hanger
3. Set the mount at Zero Position. The arrow mark on
dovetail saddle should point upward. Remove
dovetail saddle from the mount by releasing 4
screws.

AZ Mount Pro Binocular Adapter Assembly

4. Release 4 screws on saddle adapter. remove the
adapter and rotate it 90 degree. Re-install the
screws and tighten them.
You have to rotate the saddle adapter itself, not by
releasing the locking knob to rotate it wth the mount
ALT axle.
5. Install bino dovetail saddle onto the long bino
adapter plate.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AZ Mount Pro and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for iOptron AZ Mount Pro

  • Page 1 AZ Mount Pro Binocular Adapter Assembly Tool Needed: A set of metric Allen wrench Parts Included: 4. Release 4 screws on saddle adapter. remove the adapter and rotate it 90 degree. Re-install the screws and tighten them. 1. Tighten locking knob 2.
  • Page 2 6. Install the subassembly onto the AZ Mount Pro, with bino dovetail saddle on power switch side. This is important! Otherwise it will blocked by the mount body when slewing. 7. Thread in CW shaft in to one of three holes on the long bino adapter bar.

This manual is also suitable for:

8956

Table of Contents