Advertisement
6. Install the subassembly onto the AZ Mount Pro,
with bino dovetail saddle on power switch side. This
is important! Otherwise it will blocked by the
mount body when slewing.
7. Thread in CW shaft in to one of three holes on the
long bino adapter bar. Usually use the lowest one.
8. Install counterweight first. You may release the
mount ALT locking knob to set the CW at the lowest
position. Then mount the bino onto included
dovetail plate. Or you may use your own adapter
first then attach to bino dovetail plate. Slide the
dovetail plate into the bino dovetail saddle. Make
sure that the STOPPER on the play is on top when
the mount is at Zero Position. It will prevent the
scope slide out from the saddle accidently.
Advertisement
