PedalPCB NuDrive Manual

Controls

• Volume – Controls the overall output volume

• Tone – Controls the post-gain high frequencies

• Drive – Controls amount of signal gain

All trademarks and registered trademarks are the property of their respective owners. The company, product, and service names used in

this web site are for identification purposes only. Use of these names, logos, and brands does not imply endorsement.

NuDrive

Revision 12.28.19

Table of Contents

Do you have a question about the NuDrive and is the answer not in the manual?

Page 1 All trademarks and registered trademarks are the property of their respective owners. The company, product, and service names used in this web site are for identification purposes only. Use of these names, logos, and brands does not imply endorsement. Copyright © 2019 - PedalPCB.com...
Page 2 POTENTIOMETERS VOLUME B100K TONE DRIVE B500K TRIM POTS (3362P) 470K 100n 470K 100n BIAS1 1K BIAS2 1K PIN HEADERS NUTUBE 2 x 4-pin 2.54mm Male Pinheader KORG NUTUBE Common offboard components (enclosure, footswitch, jacks, etc) are not listed Copyright © 2019 - PedalPCB.com...
Page 4 PCB to prevent microphonic vibrations. NuTube Assembly Instructions 1) Install NuTube device on 6P1 carrier PCB 2) Solder 2 x 4-pin pinheaders to main NuDrive PCB 3) Attach 6P1 carrier PCB assembly to main NuDrive PCB Copyright © 2019 - PedalPCB.com...