PedalPCB 2020 Edition Parentheses Fuzz Manual

Controls

• Distortion

• Filter

• Amplitude

• Clipping (Rotary or Toggle Switch)

• Octave Blend

• Boost

All trademarks and registered trademarks are the property of their respective owners. The company, product, and service names used in

this web site are for identification purposes only. Use of these names, logos, and brands does not imply endorsement.

Parentheses Fuzz

(2020 Edition)

Revision 09.22.20

• Active/Bypass (Footswitch)

• Octave (Footswitch)

• Boost (Footswitch)

Table of Contents

Do you have a question about the 2020 Edition Parentheses Fuzz and is the answer not in the manual?

Page 1 All trademarks and registered trademarks are the property of their respective owners. The company, product, and service names used in this web site are for identification purposes only. Use of these names, logos, and brands does not imply endorsement. Copyright © 2020 - PedalPCB.com...
Page 2 In Version 1 of the original pedal D1 and D2 were installed backwards, this was corrected in Version 2. NOTE: On some germanium diodes the stripe is on the Anode end of the diode instead of the Cathode. This should be verified with a DMM before installing. To build Version 1 To build Version 2 Install D1 and D2 with cathodes pointing down. Install D1 and D2 with cathodes pointing up. 2P4T Mini Rotary Clipping Switch https://www.pedalpcb.com/product/mini-rotary-switch-2p4t/ D8 and D9 are only needed when using Rotary clipping switch. These can be omitted if using Toggle switch. Common offboard components (enclosure, footswitch, jacks, etc) are not listed Copyright © 2020 - PedalPCB.com...