PAD100-SB
Addressable Sounder Base
Description
The Addressable Sounder Base 6" (PAD100-SB) is a sounder base that may be utilized in a variety of
applications. The base has a locking feature for the sensor that may be used or removed in the field.
Once the head is removed, the sounder is accessible in the bottom of the unit.
The base has an independent sounder module that may be programmed as a single station, zone or
all call sounder. The PAD100-SB passes through the sound pattern sent to the sounder, therefore it
may reproduce in any pattern the power supply provides.
The panel will support any combination of sensors or modules on the SLC. The PAD100-SB does not
consume an address on the loop and is fully programmable to operate with any input. Once activated
the sounder will also follow the input from the power source and deactivate accordingly.
Detector Base Mounting
PAD100-SB should be mounted directly on the electrical box. The mounting holes are configured for
a single gang, double gang, octagon or 4" square box.
DS1348
Revised: 20-Aug-2019
P/N 97674
Using the two included
screws, attached the
detector base to detector
bracket.
© 2017 Janus Fire Systems. All rights reserved (5/2017) Janus Fire Systems® is a registered trademark of Janus Fire Systems.
Features
•
Integrated Sounder in base
•
75 dB (UL 464 Listed) sounder output
•
Sounder independent of sensor, allows for a single
station, grouped or all-call
•
May be mapped to any device connected to the
control panel
•
Terminals accept 22 to 12 AWG wire sizes
•
Supports Class A, Class X and Class B wiring
•
Does not require SLC Loop address
•
UUKL Listed for Smoke Control
Specifications
Working Range for SLC: 24 VDC
Working voltage range for PWR: 16 - 33 VDC
Active current for PWR: 30 ma
Sound pressure level: 75dB/10ft (min.) as per UL464
Installation temperature range: 32°F to 120°F (0°C to 49°C)
Operating relative humidity range: 0% to 93% (Non-condensing)
Start-up time: Max. 1 sec.
Maximum number of devices per zone: 127
Color: Eggshell White
Height: 0.75 in (19 mm)
Diameter: 6.3 in (166 mm)
Alignment Features
Mount the detector
bracket to the back box
using the mounting
screws.