Setting Your Meter - GlucoRx X6 Owner's Manual

Setting Your Meter

Setting your meter to the correct date and time will ensure the accuracy
of your test results. Follow the steps below when you first start using
the meter. When you change the meter battery or start using the meter
again after taking the batteries out for a period of time (ie 3 months),
you should check and update the following settings:
Entering the Settings Mode (a)
Start with the meter off (no test strip inserted). Press and hold ◄ and
► at the same time for 3 seconds.
1. Setting the date
The sequence of the date setting is: YEAR → MONTH → DAY.
With the YEAR / MONTH / DAY flashing in sequence, press ◄ or ► to
select the correct number. Press M.
2. Setting the time and format
With the HOUR / MINUTE flashing in sequence, press ◄ or ► to select
the correct number. Press M.
Press ◄ or ► to select the desired time format (12h or 24h). Press M.
3. Setting the uric acid measuring unit
With the measuring unit flashing, press ◄ or ► to switch between mg/
dL and µmol/L. Press M.
4. Setting the blood glucose's measuring mode target range
The sequence of the low and high target range setting is: Gen low →
Gen high → AC low → AC high → PC low →PC high. With the target
range settings flashing in sequence, press ◄ or ► until the desired
target number appears. Press M.
You may refer to the table below to set your target range:
GEN AC PC
LOW
3.3 – 5.5 mmo/L 3.3 – 5.5 mmo/L 3.3 – 5.5 mmo/L
HIGH 5.6 – 12.2 mmo/L 5.6 – 12.2 mmo/L 5.6 – 12.2 mmo/L
11