Installation Instruction; Installation And Setting - LG PWFMDB200 Installation Manual

Number Classification Specifications
Power
③ Communication
④ LED
Change product
⑤
Switch
⑥
Reset the power
Temperature
0 ℃ ~ 40 ℃
Spec.
Storage Tempera-
-20 ℃ ~ 60 ℃
ture
NOTE :
USB port (C-Type) is a function not used in the corresponding
product.
12 Cloud Gateway
Other types
Use of the output power of
12 V
the outdoor unit.
RS485 Maximum 1 Km
Ethernet 10/100 Mbps
Wi-Fi 2.4 GHz
Left (Product mode, red) /
2ea
Right (Power, green)
Registration (LED dim-
ming) ↔
mode
Use (LED lighting)
-
Use Temperature
Storage Temperature

Installation instruction

Installation and setting

This page describes the installation and setting methods to set up
the controller.
To use the controller, an environment must be established in which
the controller and the device (Air conditioner/ ventilation, etc.) can
communicate with each other and the devices must be registered
through the controller.
You need to install in the following order.
STEP 1. Installation environment inspection and equipment
address setting
Before installing the controller, check the network configuration
with the device interlocked to the power supply to the controller,
and assign the connected device a nonoverlapping address.
STEP 2. Product installation
Install the controller and connect the power and communication
lines.
STEP 3. Search indoor unit device
Search for the indoor unit device you want to use and save it to the
product.
STEP 4. Install ThinQ app and register an account
See attached form 'Connecting LG ThinQ and LG Electronics'.
STEP 5. Connect and use ThinQ app
Interlocking with the ThinQ app to control/monitor the searched in-
door unit.
Installation Manual 13