Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Circor IMO 110
Summary of Contents for Circor IMO 110
- Page 1 INSTRUCTION MANUAL PARTS LIST 110 / 210H CANNED MOTOR PUMPS WARNING This Special Instruction Manual and General Instructions Manual, CA-1, should be read thoroughly prior to pump installation, operation or maintenance. SRM00073 Rev. 01 (21-0001) October, 2021...
- Page 2 READ THIS ENTIRE PAGE BEFORE PROCEEDING FOR THE SAFETY OF PERSONNEL AND TO PREVENT DAMAGE TO THE EQUIPMENT, THE FOLLOWING NOMENCLATURE HAS BEEN USED IN THIS MANUAL: DANGER Failure to observe the precautions noted in this box can result in severe bodily injury or loss of life.
- Page 3 GENERAL INSTRUCTIONS NOTE: Individual contracts may have specific provisions that vary from this manual. Should any questions arise which may not be answered by these instructions, refer to General Instructions Manual, CA-1, provided with your order. For further detailed information and technical assistance please refer to Imo Pump, Technical Service Department at (704) 289-6511.
- Page 4 INSTALLATION WARNING This Equipment is limited to handling fluids compatible with motor windings and insulation. Provide suitable safety and emergency systems to protect personnel and property from injury due to pump malfunction, If pump handles hazardous fluids, provide for safety in event of pump leakage or malfunction. CAUTION ATTENTION Piping to pump MUST be independently supported and not allowed to impose...
- Page 5 OPERATION Structural Limits Operating conditions, such as speed, fluid viscosity, inlet pressure, discharge pressure, temperature, filtration, duty cycle, mounting etc. are interrelated. Due to these variable conditions, specific application limitation may be different from structural limitations. This equipment must not be operated without verification that operating requirements are within its capabilities.
- Page 6 Tools Standard shop tools are required for the procedures given in this manual. An accurate torque wrench must be used to tighten all hex bolts and cap screws CANNED MOTOR PUMP DISASSEMBLY AND ASSEMBLY INSTRUCTIONS NOTE: The below disassembly procedure applies to the pump only. The motor is not field repairable and must be returned to the factory for repair or replacement.
- Page 8 CIRCOR 1710 Airport Road PO Box 5020 Monroe, NC USA 28111.5020 : +1. 877.853.7867 @circor.com .com...
Need help?
Do you have a question about the IMO 110 and is the answer not in the manual?
Questions and answers