Delta 36-851 Instruction Manual page 9

FEED RATE ADJUSTMENTS
(For 36-851 single phase and 36-852 three phase models ONLY!)
These stock feeders utilize feed rates of 13, 26, 36 and 72 feet per minute or 4, 8, 11 and 22 meters per minute.
You can find the gear arrangement and feed rate chart attached to the inside cover (A) Fig. 6 of gear box.
To remove the gear box cover (A) Fig. 6, turn the two knobs (B) counter-clockwise and remove the cover (A). The num-
bers shown in the circles on the chart (Fig. 7) indicate the number of teeth on the gears (C) and (D).
With the 25 and 40 tooth gears in the arrangement shown at (C) Fig. 7, the feed rate is 13 FT/MIN (4 M/MIN) in low
speed, and 26 FT/MIN (8 M/MIN) in high speed. By interchanging the position of the 25 and 40 tooth gears (D) Fig. 7,
the feed rate is 36 FT/MIN (11 M/MIN) in low speed, and 72 FT/MIN (22 M/MIN) in high speed.
B
When you rotate the motor control switch (A) Fig. 8 to
the "turtle" (B), the range of feed rate is 13 and 36
FT/MIN (4 and 11 M/MIN), depending on the gear
arrangement as shown on chart (Fig. 7).
When you rotate the motor control switch (A) Fig. 8 to
the "rabbit" (C), the range of feed rate is 26 and 72
FT/MIN (8 and 22 M/MIN), depending on the gear
arrangement as shown on chart (Fig. 7).
FEED RATE ADJUSTMENTS
(For 36-855 single phase and 36-856 three phase models ONLY!)
These stock feeders utilize feed rates of 6.5,13, 18, 22, 36, 43, 55 and 108 feet per minute, or 2, 4, 5.5, 6.7, 11, 13,
16.5 and 33 meters per minute.
You can find the gear arrangement and feed rate chart attached to the inside cover (A) Fig. 9 of the gear box.
To remove the gear box cover (A) Fig. 9, turn the two knobs (B) counter-clockwise and remove the cover. The numbers
shown in the circles on the chart Fig. 10 indicate the number of teeth on the gears (C) and (D).
With the 40 and 25 tooth gears in the arrangement shown at (C) Fig. 10, the feed/speed rates are 6.5, 13, 22 and 43
FT/MIN (2, 4, 6.7 and 13 M/MIN), depending on the motor and gear speeds.
By interchanging the position of the 40 and 25 tooth gears, (D) Fig. 10, the feed/speed rates are 18, 36, 55 and 108
FT/MIN (5.5, 11, 16.5 and 33 M/MIN), depending on the motor and gear speeds.
A
Fig. 6
A
B
Fig. 9
C
D
B
C
D
Fig.10
9
E
A
Fig. 7
C
A
Fig. 8
E
F