Functional Description; Carton Contents; Assembly - Delta 36-851 Instruction Manual

Table of Contents

FOREWORD

The Delta Model 36-851 four-speed, three-roller Stock Feeder is powered by a 1 hp, 240V, single-phase, reversing motor.

This unit comes with 3 rubber feed rollers, vertical and horizontal support columns, universal joints, and a lubricating

gun.

The Delta Model 36-852 four-speed, three-roller Stock Feeder is powered by a 1 hp, 230V, three-phase, reversing motor.

This unit comes with 3 rubber feed rollers, vertical and horizontal support columns, universal joints, and a lubricating

gun.

The Delta Model 36-855 eight-speed, four-roller Stock Feeder is powered by a 1 hp, 240V, single-phase, two-speed

reversing motor. This unit comes with a two-speed gear lever, 4 rubber feed rollers, vertical and horizontal support

columns, universal joints, and a lubricating gun.

The Delta Model 36-856 eight-speed, four-roller Stock Feeder is powered by a 1 hp, 230V, three-phase, two-speed

reversing motor. This unit comes with a two-speed gear lever, 4 rubber feed rollers, vertical and horizontal support

columns, universal joints, and a lubricating gun.

NOTICE: The photo on the manual cover illustrates the current production model. All other illustrations contained in

the manual are representative only and may not depict the actual color, labeling, or accessories and are intended to

illustrate technique only.

1) Stock Feeder assembly

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from

all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone,

gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household

floor paste wax.

For your own safety, do not connect the machine to the power source until the machine is com-

pletely assembled and you read and understand the entire instruction manual.

3/8" Wrench

5/16" Wrench

INSTALLING THE TABLE MOUNTING BRACKET

Decide on the location you wish to mount the stock feeder on

your machine. Refer to Figs. 16, 17, and 18 for assistance

when mounting the stock feeder assembly to a table saw,

jointer, or shaper. To mount the stock feeder assembly to a

machine table:

1. Position the mounting bracket (A) Fig. 2 at your desired

location.

2. Mark the location where four mounting holes, three of

which are shown at (B) Fig. 2 are to be drilled.

3. Center punch and drill four 3/8" diameter holes at the

locations marked in STEP 2.

NOTE: Do not drill through any table ribs or table supports.

4. Fasten the mounting bracket (A) Fig. 2 to the table with a

2" bolt with a flat washer through each hole. Secure the

bolts from underneath with a flat washer, a lockwasher,

and a hex nut.