Remote Control; Overheat Protection; Tip-Over Protection; Specification - HOMCOM 820-258V80 Assembly & Instruction Manual

Warning:
The heater will remain hot for some time after it is turned off; handle with care.

REMOTE CONTROL

Please use Lithium battery CR2025 3V.
NOTE: the remote control buttons perform the same functions as those on the control panel
on the unit except the temperature settings.

OVERHEAT PROTECTION

This heater is protected with an overheat protection that switches off the appliance
automatically in case of overheat, e.g. due to the total or partial obstruction of the grids. In
this case, unplug the appliance, wait about 30 minutes for it to cool and remove the object
which is obstructing the grids. Then switch it back on as described above. The appliance
should operate normally. Should the problem persist, please contact the nearest customer
service.

TIP-OVER PROTECTION

This heater is protected with a safety switch that turns off the appliance automatically when
the heater falls over, or is at an excessive angle from the horizontal. This helps prevent
accidents, and the heater will back to the standby mode when it is put back upright, press
the buttons on control panel or remote control to reset the heater

SPECIFICATION

Model No 820-258V80 / 820-258V80BK
Voltage 120V AC
Frequency 60Hz
Output Power (W) 1500W
3