Download Print this page

Nukeproof MEGAWATT 297 Manual

How to remove and install battery

H o w t o r e m o v e a n d i n s t a l l y o u r N u k e p r o o f M e g a w a t t b a t t e r y

I T E M s r e q u i r e d

•

4mm hex key

r e m o v a l

1. Set your bike upright somewhere safe and look

under the downtube

3. Loosen the bottom right hand bolt on the battery

door 1 full turn using your 4mm hex key

2. Loosen the bottom left hand bolt on the battery door

1 full turn using your 4mm hex key

4. Fully remove the top battery door bolt

Table of Contents

Need help?

Do you have a question about the MEGAWATT 297 and is the answer not in the manual?

Page 1 H o w t o r e m o v e a n d i n s t a l l y o u r N u k e p r o o f M e g a w a t t b a t t e r y I T E M s r e q u i r e d •...
Page 2 5. Slide the battery door upwards to remove 6. Using your 4mm hex key, carefully turn the silver battery release bolt CLOCKWISE 7. The battery should slide forwards and stop as per 8. Push the silver clip down to fully release the battery photo 9.
Page 3 I n s t a l l a t i o n 10. Check the battery holder to ensure it is in good condition and there is no damage to any part of it 11. Rotate the battery so that the locating plastic part on 12.
Page 4 15. Tighten the top bolt first using your 4mm hex key 16. Tighten the lower left bolt using your 4mm hex key 17. Tighten the lower right bolt using your 4mm hex key Your battery has now been refitted and you are ready to ride...