Table of Contents
Advertisement
SHANGHAI BAUDCOM COMMUNICATION DEVICE CO.,LTD
Using Safety Precautions
Before installing and using this product, please read the following carefully. The Company does not
assume any responsibility for any loss due to security breaches caused.
Lasers and erbium-doped fiber amplifier output power laser radiation is not visible, can not
look directly at the device connector end when it works to avoid burning eyes and skin.
Equipment includes precision optics, in order to avoid damage to the severe impact of its
constitution, please avoid excessive vibration and impact. Pigtail easily sacrificed, so be
careful.
Equipment containing electrostatic sensitive devices, handle it carefully and make sure the
ground is good, the power supply is normal.
Attention of optic fiber end face:
1、Before using, please be sure to keep the input and output end face of the optic fiber clean,
especially if the output end face is dirt, then it is easy to make the output end face burned
and the output power will be decreasing. When cleaning the optical fiber end face or
insert patch cords, please turn off the input light first.
2、The correct order of plugging optical port is:
Inserting: first insert optical patch cord of output port, then insert optical patch cord of
input port.
Pulling out: first pull optical patch cord of input port, then pull optical patch cord of
output port.
3、This kind amplifier is a high precision and high stability product, in order to have high
stability output power, please use optical patch cord with good quality and which
connectors are match with the device to connect with the output port. In principle, the
optical patch cord should be as short as possible, and do not let it voluntary movement.
If there are any questions, please contact our company. Do not disassemble the module,
otherwise it will cause irreparable damage
Website: www.baudcom.com.cn
Tel: +86 21 37709251
Email: info@baudcom.com.cn
Advertisement
Table of Contents
