Timer Operation - Emerson MS3103 Owner's Manual

TIMER OPERATION

The timer facility allows you to set the unit to switch itself on and off automatically,
for example, to wake you up each morning.
While setting up the timer, make sure you carry out each step within 5 seconds,
otherwise the operation will time out and you will have to start again.
NOTE: During timer setup, always check the AM / PM indicator (to the left of the
time) to ensure you make the correct settings.
1.) Select the radio station or CD you wish to play when the unit switches on. (For
CD this can be a programmed selection of tracks if desired.)
2.) Press TIME MODE/REMAIN button repeatedly until TIMER ON indicator
flashes at the right of the display, then press TIME-SET/MEMORY button
immediately.
The switch-on time (hour setting) will flash.
3.) Immediately press
AM or PM is correct), then press TIME-SET/MEMORY button.
The minute setting will flash.
4.) Immediately press
MEMORY button again.
5.) Press TIME MODE/REMAIN button repeatedly until TIMER OFF indicator
flashes at the right of the display, then press TIME-SET/MEMORY button
immediately.
The switch-off time (hour setting) will flash.
6.) Immediately press
MEMORY button.
The minute setting will flash.
7.) Immediately press
MEMORY button.
The switch-on and switch-off times have now been set. To check them at any time,
press TIME MODE/REMAIN button repeatedly to step through the TIMER ON
and TIMER OFF settings on the display.
MS3103_ib012803.p65
or buttons to set the hour (making sure the flashing
or buttons to set the minute, then press TIME-SET/
or buttons to set the hour, then press TIME-SET/
or buttons to set the minute, then press TIME-SET/
28
28 28/1/2003, 11:36