Table of Contents
Advertisement
ABOUT CASSETTE TAPES
Whenever you record on a cassette any previously recorded material is erased
as the new material is accorded. To prevent you from accidentally erasing material
which you wish to save, blank cassettes are equipped with erase prevention tabs
for each side of the tape. If the erase prevention tab for side A is removed, you
cannot accidentally record on side A. The record key cannot be depressed if the
erase prevention tab on the cassette has been removed.
To prevent accidental erasing on side A of a cassette use a small screw driver or
similar tool to break off the erase prevention tab for side A, this prevents the
record key from locking.
TAB FOR SIDE A.
If later you do wish to record on side A of the cassette, cover the tab opening with
a piece of cellophane tape. This will allow the record key to function again.
CASSETTE CARE
Two common causes of trouble experienced when using cassettes are:
1.) Tape jamming — Leading to uneven speed in playback, and
2.) Tape tangling — Where the tape wraps itself around vital parts of themechanism.
To reduce the likelihood of these problems occurring, the following precautions
should be observed:
• Check that there are no loose layers of tape visible
through the cassette center window (see Fig. 1).
Take up any loose layers, using a pencil or hexagonal
barrelled ballpoint pen, before inserting the cassette
into the machine (see Fig. 2).
• If the cassette feels "tight" while performing operation
shown (see Fig. 2), the tape may be jamming due to
"ridges" formed in the winding of the tape (visible
through the center window). These may be removed,
in most cases, by fast winding of the cassette from
one end to the other and back again.
MS7625_ib.p65
CARE AND MAINTENANCE
A
COVER OPENING WITH TAPE
IN ORDER TO RECORD AGAIN.
14
14
A
02/19/2001, AM 10:59
Advertisement
Table of Contents
