PROLUMIA 41060630 Operating Instruction page 12

PIR SENSOR - REMOTE CONTROLLER
Please note:
All 'Lux' data indicated in this manual is based on sunlight. If there is another light source (such as LED) at the working area, the sensitivity could
be diff erent. This is because the sensor has diff erent performance at diff erent spectra.
The default setting is PIR sensor mode
IR emitter
Daylight sensor: Press the button to set
the daylight threshold.
Hold time: Press the button to set the
duration time.
Hold time: 5/30/90 seconds,
or 5/15/30 minutes.
Daylight threshold setting:
5/15/30/50 Lux.
Insulation gasket:
Please pull out the insulation gasket
before use and put it back after use to
keep the battery longer life.
PIR SENSOR - SENSOR SETTING
This energy-saving LED fl oodlight is controlled by an infrared sensor and light sensor. It will turn on automatically when a person is detected and
when the ambient light is lower than the daylight threshold. It keeps working when movement is detected inside the area. It will automatically
turn off after a set duration when a person has moved outside the area.
The hold time and ambient light threshold can be set with an IR remote controller. Please point the controller to the fl oodlight when pressing the
setting buttons. A red signal will fl ash to indicate that the setting is well received.
Step 1: Power on the lamp.
Step 2: Set the Daylight threshold.
Step 3: Set the Hold time.
12
www.prolumia.com
Disable daylight sensor:
By disabling the daylight sensor, the
light will turn on as soon as the IR sensor
detects movement, regardless of the
ambient light.
(This function is for PIR testing during
daytime.)
PIR disable setting — Mode setting
1. Disable PIR sensor
— (Daylight sensor mode):
Press this button for 3 seconds, fl oodlight
fl ickers twice. Motion detection function is
now disabled. It now only works as a light
sensor. The lamp turns on when ambient
light is lower than 25 Lux (hold time is at
least 2 min.), and automatically off when
ambient light goes up.
(All other buttons are inactive at this mode.)
2. Enable PIR sensor
— (PIR sensor mode):
Press this button for 3 seconds again,
fl oodlight turns on for 1 second. Motion
detection function is now active.
(The default setting is PIR sensor Mode.)