Table of Contents
Advertisement
Introduction
I/O Shield Connector
PS/2 Mouse
PS/2 Keyboard
Power-On/Off (Remote)
Note: For maintaining the DDR SDRAM power during STR (ACPI S3) function, it is
strongly recommend to use power supplies that have a +5VSB current of (>=)
1A (1000mA). Please check the 5VSB’s specification that has been printed on
the power supply’s outer case.
Note: The board requires a minimum of 250 Watt power supply to operate. Your
system configuration (amount of memory, add-in cards, peripherals, etc.) may
exceed the minimum power requirement but to ensure that adequate power is
provided, use a 300 Watt (or greater) power supply.
J 3
Case (chassis) Power ON/OFF button (J 3)
Page 1-8
All manuals and user guides at all-guides.com
RJ45 LAN
Parallel Port
(Optional)
USB 2.0
COM1
port
Line-out/Front out
Figure 3: I/O back panel layout
12V 4-pin
20-pin
Figure 4: Simple ATX power ON/OFF controller
Joystick/Midi port
VGA1
Line-in/Rear out
Mic-in/Center&Subwoofer
Remote On/Off
®
Advertisement
Table of Contents
