Table of Contents
Advertisement
6
Installation
Site Preparation
1 Position the appliance on a flat, level surface
capable of supporting the entire weight of
the unit. Remember the appliance will be
significantly heavier once it is fully loaded.
2 This appliance requires a grounded and
polarized 115 VAC, 60Hz, 15A circuit (normal
household current).
3 Avoid connecting the unit to a Ground Fault
Interruptor (GFI). GFIs are prone to nuisance
tripping which will cause the unit to shut down.
GFIs are generally not used on circuits which
power equipment that must run unattended for
long periods of time.
4 The appliance must be installed according to
your local codes and ordinances.
WARNING
ELECTROCUTION HAZARD!
Electrical Grounding Required - This appliance
is equipped with a three prong (grounding)
polarized plug for your protection against
possible shock hazards.
• NEVER remove the round grounding prong
from the plug.
• NEVER use a two-prong grounding adapter.
• NEVER use an extension cord to connect
power to the unit.
Where a two-prong wall receptacle is
encountered or a longer power cord is required,
contact a qualified electrician to have it replaced
in accordance with applicable electrical codes.
5 Position the appliance to allow free air flow
through the front grille.
6 Wipe out inside of unit with a damp cloth.
7 Be sure to install the Anti-Tip bracket. Follow the
instructions provided with the Anti-Tip bracket
kit.
WARNING
The Anti-Tip Kit must be installed on this unit
before it is used. Double stacking units may
cause serious personal injury.
Leveling the Appliance
Position the appliance on a flat, level surface capable
of supporting the entire weight when full.
This appliance contains four (4) adjustable
leveling legs. Turn the legs clockwise to raise and
counterclockwise to lower.
Advertisement
Table of Contents
