Electrolux E24RD75HPS - 24" Double Drawer Refrigerator Service Data Sheet

PERFORMANCE DATA NO LOAD & NO DOOR OPENINGS
AT MID-POINT CONTROL SETTING
type a with run/start
65°F (18°c) ambient
capacitor
Operating Time N/A
Temperature 34º F to 45º F
Low Side Pressure 30 to 45 psig
(cut-in) 208 to 310 kPa
Low Side Pressure -2 to 4 psig
(cut-out) -14 to 28 kPa
High Side Pressure 90 to 120 psig
(last 1/3 cycle) 621 to 827 kPa
Wattage (last 1/3 cycle) 85 to 125
Amps (running) .75 to 1.2
Base Voltage 115 vac (127 vac max)
cOndenser Fan mOtOr
Watts rpm
1100 CW Opposite
3.1
Shaft
evapOratOr Fan mOtOr
1.7 each 9000
impOrtant: pLease return this sheet tO it's
OriGinaL LOcatiOn.
service data sheet
reFriGeratOr draWers - r134a
impOrtant saFety nOte
90°F (32°c) ambient
The information provided herein is designed to assist qualified repair
30 to 50%
personnel only. Untrained persons should not attempt to make repairs
34º F to 45º F
due to the possibility of electrical shock. Disconnect power cord before
30 to 45 psig
servicing this appliance.
208 to 310 kPa
impOrtant
-2 to 4 psig
If any green grounding wires are removed during servicing, they must
-14 to 28 kPa
be returned to their original position and properly secured.
130 to 175 psig
896 to 1207 kPa
85 to 125
cautiOn
.75 to 1.2
all electrical parts and wiring must be shielded from torch flame.
dO nOt allow torch to touch insulation; it will char at 200°F
and flash ignite (burn) at 500°F. excessive heat will distort the
amps
plastic liner.
0.03 Running
nOte
.02 each
Your Electrolux refrigerator drawers has been designed for built-
in installation. Your refrigerator drawers do not require additional
air space for top, sides or rear. The front grille must nOt be
obstructed.
To ease unit installation and removal, it is recommended that the
cabinet rough opening dimensions be increased by at least ¼ inch
over the dimensions given for your unit.
WarninG
double drawer refrigerator drawers are designed to be built-
in only. they can not be used for free-standing.
all screws supplied with the anti-tip Kit are for mounting
the bracket directly to wall studs. these screws will not work
if used with sheetrock (dry wall) or anything other than wall
studs.
242007200
icOn unit dimensions
tm
Model Width
Designer 23 / inch 34-35 inches
13
16
Professional 23 / inch 34-35 inches
13
16
2.75"
2.75"
Height Depth
26 / inch
3
4
26 / inch
3
4
icOn
tm
designer
icOn tm
professional
3.25"