BBPOS QB33 Instruction Manual

Intuit Node (QB33 / CHB80) Instruction Manual
Follow your application instruction to start the transaction process, then insert or tap card to complete the
transaction.
** If you pay via inserting EMV IC card, please ensure that the EMV chip of the card is facing the right direction. If
you pay using NFC card, please ensure you tap the NFC payment card within 4cm range on top of the NFC marking.
NFC Status Indictors
"TAP" + "BEEP"- Ready for tapping card
"CARD READ" - Reading card information
"PROCESSING" + "BEEP" - Card reading process successfully completed
"APPROVED" + "BEEP" - Transaction completed
A rolling dot is shown in LED matrix, "." - Standby mode
Cautions & Important Notes

Ensure the device is fully charged before use.

Please ensure EMV chip of the card is facing the right direction when inserting card.

The NFC card should be tapped within 4 cm range on top of the reader mark.

Don't drop, disassemble, tear, open, crush, bend, deform, puncture, shred, microwave, incinerate,
paint or insert foreign object into the device. Doing any of which will damage the device and void
the Warranty.

Don't immerse the device into water and place near washbasins or any wet locations. Don't spill
food or liquid on the devices. Don't attempt to dry the device with external heat sources, such as
microwave or hair dryer. Don't use any corrosive solvent or water to clean the device.

Recommend using dry cloth to clean the surface only.

Don't use any sharp tools to point the internal components, connectors or contacts, doing which
may lead to device malfunction and void the Warranty simultaneously.