Eiki LC-HDT10 Owner's Instruction Manual page 44

Eiki multimedia projector model lc-hdt10 owner's instruction manual
Hide thumbs Also See for LC-HDT10:
Table of Contents

Advertisement

APPENDIX
Problem:
Remote Control Unit
does not work.
SERVICE
WARNING: High voltages are used to operate this projector. Do not attempt to open cabinet.
You can often correct operating problems yourself. If a projector fails to work properly, see "TROUBLESHOOT-
ING" section on pages 43-44. To correct failure, try "Solutions".
The CE Mark is a Directive conformity mark of the European Community (EC).
44
G Check batteries.
G Make sure nothing is between Infrared Remote Receiver and Remote Control Unit.
G Make sure you are not too far from a projector when using Remote Control Unit.
Maximum operating range is 16.4' (5m).
G Check transmitted signal mode from Remote Control Unit.
(See "SETTING" section on page 37.)
This symbol on the nameplate means the product is Listed by Underwriters
Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety
standards against risk of fire, casualty and electrical hazards.
Try these Solution

Advertisement

Table of Contents
loading

Table of Contents