Table of Contents
Advertisement
SERIAL PORT
IN TERMINAL
If you control a projector by computer,
you must connect a cable (not provided)
from your computer to this terminal.
SERIAL PORT
OUT TERMINAL
This terminal outputs signal
from SERIAL PORT IN. More
than two projectors can be
controlled with one computer
by connecting SERIAL PORT
IN. of another projector to this
terminal.
R/C JACK
When using Wired / Wireless Remote
Control Unit as Wired Remote
Control, Connect Wired Remote
Control Unit to this jack with Remote
Control Cable (supplied).
(Refer to page 18.)
SERIAL PORT IN
SDI IN1 SDI IN2
SERIAL PORT OUT
R/Pr
R/C JACK
USB
AUDIO OUT
R
L
RESET
(MONO)
AUDIO OUTPUT JACKS
Connect an external audio
amplifier to these jacks.
(Refer to P14, 15.)
CONNECTING PROJECTOR
USB PORT (Series B)
This port is used to control a projector
with computer.
Connect USB port of computer to this
port.
SDI OUT
G/Y
B/Pb
H/HV
V
R
DVI
R
RESET BUTTON
This projector uses a micro processor to control unit.
Occasionally, micro processor may malfunction and
need to be reset. This can be done by pressing
RESET button with a pen, which will shut down and
restart unit. Do not use RESET function excessively.
AUDIO
CONTROL PORT
L
(MONO)
AUDIO
CONTROL PORT
L
(MONO)
13
Advertisement
Table of Contents
