Table of Contents
Advertisement
2.1. Panel Layout
2.1.1. Front Panel
RESET
When RESET is pushed, system settings will be set to factory defaults.
Readmy
System status indicators, Orange. Ready is flashed once per second to
&Com
indicate system is alive. When COM port is active, COM LED is lighted.
WAN & LAN Ethernet port indicators, Green. The LED flickers when LAN or WAN
port is sending or receiving data.
Link/Act.
Link status indicators, Green. The LED flickers when the corresponding
port is sending or receiving data
10/100
10/100 status indicators, Green. The LED flickers when the
corresponding port is transmitting or receiving data in 10 or 100Mbps.
Port 1 - 4
LAN port socket (RJ-45). These are where you will connect to device on
your local area network, for example HUB and switch.
2.1.2. Rear Panel
WAN
WAN port socket (RJ-45). This is where you will connect to your cable (or
DSL) modem or Ethernet router.
COM
Serial port connector (9-pins D-type male). This is where you will connect
your modem. This port is also a console port.
Chapter 2 Hardware Installation
Figure 2-1 Front Panel
Figure 2-2 Rear Panel
-6-
Advertisement
Table of Contents
