Notes Of Schematic Diagram; Charts And Diagrams; Circuit Board Notes - JVC XV-N650BAG Schematic Diagrams

CHARTS AND DIAGRAMS

NOTES OF SCHEMATIC DIAGRAM

Safety precautions
The Components indentified by the symbol !
critical for safety. For continued safety, replace safety
critical components only with manufacturer's recom-
mended parts.
1. Units of components on the schematic diagram
Unless otherwise specified.
1) All resistance values are in ohm. 1/6 W, 1/8 W (refer to
parts list).
Chip resistors are 1/16 W.
K: KΩ(1000Ω), M: MΩ (1000KΩ)
2) All capacitance values are in µF, (P: PF).
3) All inductance values are in µH, (m: mH).
4) All diodes are 1SS133, MA165 or 1N4148M (refer to parts
list).
Note: The Parts Number, value and rated voltage etc. in
the Schematic Diagram are for references only.
When replacing the parts, refer to the Parts List.
2. Indications of control voltage
AUX : Active at high.
AUX or AUX(L) : Active at low.
3. Interpreting Connector indications
1
Removable connector
2
3
1
Wire soldered directly on board
2
3
1
Non-removable Board connector
2
3
1
2
Board to Board
3
4
Connected pattern on board
The arrows indicate signal path
4. Voltage measurement
1) Regulator (DC/DC CONV) circuits
REC : Colour bar signal.
are
PB : Alignment tape (Colour bar).
— : Unmeasurable or unnecessary to measure.
2) Indication on schematic diagram
Voltage indications for REC and PB mode on the sche-
matic diagram are as shown below.
1 2 3
REC mode 2.5 1.8
(5.0)
PB and REC modes
(Voltage of PB and REC modes
PB mode
are the same)
Note: If the voltages are not indicated on the schematic
diagram, refer to the voltage charts.
6. Indication of the parts for adjustments
The parts for the adjustments are surrounded with the circle
as shown below.
7. Indication of the parts not mounted on the circuit board
"OPEN" is indicated by the parts not mounted on the circuit
board.
R216
OPEN

CIRCUIT BOARD NOTES

1. Foil and Component sides
1) Foil side (B side) :
Parts on the foil side seen from foil face (pattern face)
are indicated.
2) Component side (A side) :
Parts on the component side seen from component face
(parts face) indicated.
Parts location are indicated by guide scale on the circuit board.
2. Parts location guides
Parts location are indicated by guide scale on the circuit board.
REF No. LOCATION
IC
IC101 B C
B : Foil side
(A : Component side)
C : Chip component
D : Discrete component)
2-1 2-2
Category : IC
6 A
Horizontal "A" zone
Vertical "6" zone