How To Transport Cleaner; Replacement; Lightbulb Removal And Replacement - Dirt Devil Swivel Glide Owner's Manual

1.
small text
BELT OR BRUSH REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG CLEANER BEFORE CHANGING BEL T OR BRUSHROLL.
SUB-HEADING
TO REMOVE BELT
to remove the four screws. Arrows in diagram 1 show location of screws. Flip cleaner back over and lift nozzle cover off. Slid
shaft (Diagram 2). Lift and remove brushroll (Diagram 3). Dispose of old belt.
callouts
TO REPLACE BELT
1. Place belt on motor shaft, then slip brushroll through belt. Place belt in area of brushroll without bristles (Diagram 4).
2. With belt in place, pull and slide brushroll into nozzle (Diagram 3) making sure that the brushroll end caps are in the cor
(Diagram 3a inset).
IMPORTANT: Rotate brushroll manually in both directions to make sure belt is not twisted and is properly aligned.
3. Reattach nozzle cover. Secure by replacing the screws under the nozzle base.
BELT STORAGE
See page 4. (fig. 4) - stretch belt around hooks. (fig. 5) - fold and secure belt (in a u shape) on the inside of the loops on
upright.
1.
LIGHTBULB* REMOVAL & REPLACEMENT
TOOL REQUIRED: FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK - UNPLUG CLEANER BEFORE REMOVING OR REPLACING LIGHTBULB.
This cleaner uses a common automotive lamp #906, 13.0 volts. For
1. Remove front panel (See page 9, Diagram 1). Lean cleaner handle back. Insert end of standard screwdriver into the side slot a
outward to pop headlight lens out.
2. Pull bulb out of socket to remove. Push bulb into socket to replace (Diagram 2).
3. Snap headlight lens panel back into place. Reattach front panel.

HOW TO TRANSPORT CLEANER

Use the carrying handle on the back of the cleaner to move cleaner from room to room (Diagram 3).
NOTE: Do not push cleaner forward while leaning on back casters, pull cleaner on back casters, or attempt to lift cleaner using upper handle.
* Not available on all models
2.
Flip cleaner to expose nozzle base as shown in
3.
(Diagram 1). To remove nozzle cover, use Phillips screwdriver
2.
bulb replacement call 1-800-321-1 134 or your local auto parts
8
3a.
4.
BELT STYLE:
3.
4 5
&
e belt off motor
rect orientation
the back of the
store.
nd pry