Table of Contents
Advertisement
If the burner does not ignite, turn the control knob to
4.
the off position and repeat the steps described
above. This time, hold the control knob down for
longer (up to 10 seconds).
Note:
Take the following information into account to ensure
that the appliance works correctly:
¡ The burner parts → Page 7 and the pan supports
→ Page 7 must be inserted correctly.
¡ Do not swap the burner caps around.
¡ It is important to keep the appliance clean. Clean
the ignition plugs regularly with a small, non-metallic
brush. Take care to prevent the ignition plugs from
suffering any heavy knocks.
¡ The burner holes and grooves must be clean to en-
sure a correct flame.
→ "Cleaning the burners", Page 11
6.2 Safety system
The safety system (thermocouple) interrupts the flow of
gas if the burners accidentally go out. To ignite the
burner, you must activate the system that enables the
gas flow.
Ignite the burner without releasing the control knob.
1.
a The flame ignites.
Press and hold the control knob for a further four
2.
seconds.
7 Cookware
This information has been provided to help you save
energy and avoid damaging your cookware.
7.1 Suitable cookware
Only use cookware with a suitable diameter. The cook-
ware must not protrude over the edge of the hob.
Never use small cookware on large burners. The
flames must not touch the sides of the cookware.
Burner
Minimum dia-
meter of the
cookware base
Multi-crown
22 cm
burner
High-output
20 cm
burner
Standard-output
14 cm
burner
Economy burner 12 cm
Only use cookware with a rounded base on the multi-
crown burner.
¡ The hob must have a multi-crown burner and addi-
tional wok grid.
Maximum dia-
meter of the
cookware base
30 cm
26 cm
22 cm
16 cm
6.3 Igniting a gas burner manually
In the event of a power cut, you can light the burners
manually.
Press the control knob for the selected burner and
1.
turn it anti-clockwise to the highest level.
Hold a lighter or a flame (lighter, match, etc.)
2.
against the burner.
6.4 Switching off a burner
Turn the control knob clockwise to .
▶
lights up in the display. After a few seconds, the
a
residual heat indicator appears.
6.5 Normal behaviour during operation
This behaviour is normal for the appliance:
¡ Slight hissing noise from the ignited burner.
¡ Release of odours when using the appliance for the
first time. These odours disappear after a short time.
¡ An orange flame is normal. This is due to dust in the
environment, spilled liquids, etc.
¡ Popping noise a few seconds after the burner is
switched off. This is caused by switching on the
safety system.
→ "Safety system", Page 9
¡ The additional wok grid must be correctly inserted.
→ "Accessories", Page 8
7.2 Using cookware
The selection and positioning of the cookware affects
the safety and energy efficiency of your appliance.
→ "Saving energy", Page 6
WARNING ‒ Risk of fire!
Flammable objects may ignite.
Maintain a distance of at least 50 mm between the
▶
cookware and flammable objects.
Do not use deformed cookware. Only use cookware
with a thick, flat base.
¡ Deformed cookware is not stable on the hob and
may tip over.
Place the cookware right in the centre of the burner.
¡ The cookware may tip over if it is not placed in the
centre of the burner.
Place the cookware correctly on the pan supports.
¡ The cookware may tip over if you place it directly
on the burner.
Cookware en
9
Advertisement
Table of Contents
