Denon DN-H800 Operating Instructions Manual page 14

ENGLISH
Leave your entire system (including the DN-H800) turned off until all connections between the DN-H800 and other components have
been completed.
2 Connecting the DN-H800 to an Amplifier
• Before connecting the DN-H800 to your amplifier, it is a good practice to review your amplifier's instruction manual.
• Use the white plugs for the left channel and red plugs for the right channel.
Receiver or amplifier
WHITE
WHITE
CD AUX
L
R
RED
RED
2 Connection Precautions
• Before proceeding with connections or disconnections of cables and power cords, be sure to turn all system components off.
• Ensure that all cables are connected properly to the L (left) and R (right) jacks.
• Insert plugs fully into the terminals.
• Connect the CD output jacks to the amplifier CD or AUX input jacks.
2 Wired remote control connections
• For wired remote control, use the circuit shown on the diagram below.
• Design the circuit so that the wire resistance is 0.5 /ohms or less.
C1
L ch
150 180
N N
PRESET DOWN
TUNER UNIT
C2
R ch
150 180
N N
1 2
GND
C3
CD UNIT
* 1 N 6
("N" is the number
of DN-H800 units
connected.)
2 Installation Precautions
• If the DN-H800 is placed near amplifier, tuner or other components, noise (induced hum) or beat interference may result (especially
during AM or FM reception).
If this occurs, separate the DN-H800 from other components or reorient its position.
NOTE:
Use this unit in a horizontal orientation.
When the unit is used with the front panel facing upward (and the unit is in a vertical orientation) or when the front panel is on an incline,
the will not operate properly.
14
TUNER
L
R
270 390 680
N N N
PRESET UP
270 390 680
N N N
DISC SKIP
9 8
R ch
L ch
GND
DN-H800
WHITE RED
BALANCED OUT
L R
CD SELECTED
/TUNER
UNBALANCED OUT
SELECTED
CD / TUNER
REMOTE
ANTENNA TERMINALS
L R
WHITE RED
• Up to six units can be controlled simultaneously
with one remote control unit.
1.3k 3.9k
N
N
• Wire the signal and ground lines as shown on the
TUNER ON/OFF
diagram below and connect at the remote control
inputs (C1, C2 and C3).
• Design the circuit so that the resistance of the
individual wires is 0.5 /ohms or less.
1.3k 3.9k
N N
ø
G R L 3.5mm
STEREO MINI PLUG
Power supply
outlet
Connecting two DN-H800 units (N = 2)
Remote unit
C1 C2 C3
DN-H800 DN-H800
1 2
120 V 60 Hz