Advertisement
Bellevue AJ10
Please read these instructions carefully and retain them
for future reference to ensure that the product is used
Arne Jacobsen
correctly. For your own safety, please study each step of
this instruction manual first. &Tradition is not responsible
1929
for any faults or damages caused by not following these in-
structions correctly. Do not modify this product in any way.
Contents
A Lamp
A
B Bottom plate for fixation
Tools needed
- Bulb type E14
- Electric drill
- Wrench
Safety precautions
B
- Dispose of plastic bag from packaging and do not allow
children to play with it.
- Keep product well out of children's reach.
- The lamp is only intended for interior use.
- Consult a professionally qualified electrician if in any doubt.
- Do not place the cable within reach of small children or
anywhere there is a risk of falling over it.
- If the external cable or cord of this lamp is damaged,
it must be replaced by the manufacture or a similar
qualified person in order to avoid a hazard.
Cleaning instructions
- Wipe surface of lamp shade with a soft, damp spong or
cloth, and wipe immediately after with a dry cloth.
- Do not use any abrasive cleaning tools such as steel
wool, scouring sponges or stiff brushes.
- Never use strong cleaning agents such as white spirit,
terpentine household glass cleaner or cellulose thinners.
- Only wipe the inside of the shade with a soft, damp cloth
or feather duster.
For indoor use only
E14 maximum 25W
Bulb not included
Step 1
Identify the desired location for the lamp on the table top
and mark the middle using a pencil. Next, drill a hole using
a hole drill. The hole should be 50mm in diameter for a CE
plug, and 20mm without CE plug.
Step 2
Place the lamp (A) in the drilled hole. Be sure to place
the cord in first.
Step 3
Slide the bottom plate (B) around the bolt, beneath the
table top but above the washers.
03/21
Advertisement
