Advertisement
To safely use your Air Mover, follow these instructions:
1. Unpack Air Mover from carton.
2. To use your Air Mover, place it in the area most
suitable for your application. Several factors
need to be considered: the Air Mover must be
placed close enough to an AC outlet to be
plugged in (approx. 10 feet), there must be a
minimum clearance of two feet from either
side of the Air Mover to allow for proper air
flow, and the unit should not be placed where
it can become a tripping or safety hazard.
3. Place Air Mover in the proper operating
position (0
0
, 45
Refer to the instructions further in this manual.
4. To use multiple Air Movers (up to 3 Air Movers), refer to the Multiple Air Mover
instructions below.
5. Plug Air Mover into grounded GFCI receptacle.
6. Turn Air Mover on and select air speed by turning the 3 speed switch (A) Fig.3, by turning
it clockwise to the desired speed.
7. When your drying job is completed, turn the Air Mover off and properly store Air Mover.
Using Multiple Air Movers
1. Your Air Mover comes with two 120V
receptacles (A) Fig.4 for the use with multiple
Air Movers (up to 3). To use this feature,
position the first Air Mover following the
operation instructions in the section above.
This Air mover may be turned on while
connecting multiple Air Movers.
2. Plug the second Air Mover into one of the
receptacles on the first Air Mover. Place the
second unit in the operation position and the
area most suitable for your application. The second Air Mover may now be turned on.
3. A third Air Mover can be plugged into the remaining receptacle on the first Air Mover or
plugged into one of the receptacles in the second Air Mover. The third Air Mover may
now be turned on.
4. The receptacles on the unit are equipped with a thermal protector/reset button (B) Fig.4
which will shut off power to the Air Mover should the receptacles become overloaded. If
this happens, move the switch to the off position on the first Air Mover and any Air
Movers connected to it. Wait 5 minutes or more for the Air Mover to cool down, then
press the reset button, then turn the Air Mover on again, and any Air Movers connected
to it. If the thermal protector trips again, reduce the load on the 120V receptacles. If an
extension cord is used, and thermal protector trips again, do not use extension cord.
NOTE: It is not recommended to use the receptacles on the Air Mover for appliances other
than another Air Mover of the same amperage rating.
OPERATION
0
and 90
0
) for your application.
Figure 3
Figure 4
Advertisement
