Page 1
Garmin® GPS-III+ Backup Battery Replacement If you receive a screen message that your backup battery has lost charge, it is time to replace it. Here is how. 1. Tools and supplies a. Japanese JIS Standard “Phillips” head screwdrivers. These drivers are cut in a different manner and provide a good grip on the screws.
Page 2
c. Using a jeweler’s screwdriver, gently pry up the white cable connector from the circuit board and set the back of the case aside. d. Locate the battery. It is on edge next to a capacitor just to the left of the white connector.
Page 3
e. Using a jeweler’s screwdriver, pull the plastic clamp back on the brown ribbon cable to the stops. f. Remove the screw near the metal can on the antenna end of the board. g. Gently tip the board up, hinging on the ribbon cable edge. The board will stick and it will take some leverage to get it up.